10/14/2011 01:13 PM
Install holding tanks,
Replace RV toilet
Rough in existing plumbing to tanks
Current images on top...
Most Recent Images on Top...
Top left, Bolts rusted away in the thread and could not
Right side Okay
Removed rear bumper in prep for hitch.
We found badly rusted inside brace,
It's called "Back Up Structure" MCI Part # 3K-21-12
This will not stop us from mounting hitch but you will need to be aware of this
The areas that could look like paint chips on top of the surface is actually the
holes rusted through.
Incorrect preexisting plumbing on shower head supply.
After tightening the loose fittings there was not enough length to fit into the
control valve from the shower head.
We can repair it..
Rear Bumper has rusted out brace (called "back up structure" in book)
Hot water heater mounted
Installing Sensor strips for tank level meter
Rough in for Galley
Installing tanks and parts, note stainless steel straps..
Installing all the spin welded fittings
Spinning the fittings
After fittings installed
Bracket to hold control panel
Finished installation in #3336